11 Measures to Spray Paint Your Car Like the Professionals - Auto Bodywork Paint Repair

11 Measures to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

You will be surprised to see only how you can spray on auto paint actually can not be difficult. That doesn't mean that you can just grab a tin of paint and go at it. There are some basics you have to understand. Both in the preparation and application.

Step A:

Prepare by gathering all of your items that you are going to need.

Step B:

You may need to examine the car carefully for Alloy Wheel Repair Hornchurch any rough spots. These will have to be sanded with 300 grit sand paper. Additionally, it enables the aerosol automobile paint to adhere better. Make certain all the dust dirt and debris are taken off the vehicle, once you have finished sanding. It is imperative the auto be perfectly clean.

Step C:

This will make sure that you get an overall even layer of your colored paint plus helps the paint to adhere nicely. When you spray on the primer, be sure to apply light layers and allow for drying in between. How exactly to spray car paint takes a little getting used to.

Step D:

Now you are well to the point at which you're around ready to spray on the shade. Before you begin with the auto in any case, make a few practice strokes on an object. Once you are ready, begin the passes with the paint without hesitation. If you hold the spray can or gun in one spot, you will end up getting uneven coverage and maybe the paint will run. If it happens you have a significant repair job on your had. You will most probably have instructions as to how you can spray on car paint using the spray or equipment cans.



Step E:

You might want to research this choice on the web, or check with someone that is comfortable with how to spray on car paint

Step F:

You're down to the finishing touches once you are absolutely satisfied with the shade. You may now want to apply several clear coatings. This can give the finished and polish look to the car in addition to protect the finish. Likely two layers will be adequate but it's going to be up to you. Make absolutely certain it's dry in between coats.

Step G:

If you prefer once again, you've the choice of wet sanding. Again, I suggest you request the advice of individuals that are familiar with how to spray paint a car. You need to wet sand with these grits in this order if you determine to follow this measure then. This will remove spots that could not be too light in the clear coat application.

Step H:

Now you will need to using a rubbing compound to buff the surface so you can use a 2000 grit to remove any scratches.

Step I:

You should buff the surface. To try this just use a moderate cut polish.

Step J:

As a final touch, you might want to apply several layers of wax.